Rule Automatic Bilge Pump 500GPH
A fully submersible and fully automated bilge pump that works without a float switch.
Add to your basket...
Rule Automatic Bilge Pump 500GPH Information
This fully automated, ignition protected, bilge pump automatically turns on and checks for water approximately every two and a half minutes. During this 'Check', the pump runs for about one second and measures for resistance or drag against the impeller. If resistance (water) is encountered, it will run for as long as water is present. When all the water is pumped out, the pump shuts off and returns to its two and a half minute cycle. Power use during the 'Check' mode is minimal. This pump will consume 0.20 amp hours per day in the 'Check' mode.
Constructed of a tough plastic body with a quick release integral strainer and long lasting stainless steel shaft all combining to create a robust and practical bilge pump and there is no need for a separate float switch.
A third wire is also attached for installing a manual override or warning light.
Specifications:
- Application: Bilge water
- Current: 12 volt
- Head: 6.6ft (2m)
- Output: As per products displayed
- Outlets: 3/4" (19mm)
- Maximum Current: 2.5 amps - Power use during the 'Check' mode is minimal. This pump will consume 0.20amp hours per day in the 'Check' mode.
- Cable Length: 70cm
- Dimensions: Height 100mm, Diameter 60mm
This Jabsco pump should not be run dry for long periods and is not suitable for pumping petrol or diesel. Specific pumps for pumping diesel are also available at Sheridan Marine.
