A compact, quiet, low flow 12 volt freshwater pressure pump and chrome tap kit complete with tap mounting fittings, water pump fittings and six metres of light water pipe.
This entry-level pressurised 12 volt water pump and tap kit is ideal as a low use water supply system on your boat, small craft or caravan. The double-diaphragm design self primes to 1.5m vertical lift and can run dry without damage. With approximately 6m of water pipe provided in the kit, along with all you need to install the tap and pump, you can mount the pump away from the tap itself.
The rubber feet on the pump absorb the natural movement of the pump and thus reduces vibration noise. The pre-stripped wires allow for easy installation into the electrical system and the quick connect water ports make it easy to plumb in too.
Voltage | 12v |
Output | Up to 228 litres per hour (up to 3.8 litres per minute) at up to 2.4bar / 60 gallons per hour (1 gallon per minute) at up to 35psi |
Pressure Switch | 35psi (2.4bar) OFF / 25psi (1.7bar) ON |
Head | 1.5m |
Length | 164mm |
Width | 89mm |
Height | 68mm |
Application | Fresh Water |
Outlets | 3/8" Quick Connect for 1/4" John Guest Type |
Amps | 3.5A |
Fuse Required | 4A |
Jabsco Tap & Fittings Specifications:
Tap Height | 308mm |
Tap Height Above Surface | 230mm |
Tap Height Below Surface | 78mm |
Tap Base Diameter | 26mm |
Water Pipe Diameter | 1/4" John Guest Type |
Water Tank Fitting | 3/8MNPT |
Water Pump Fitting | 1/4" John Guest Type to 3/8" Quick Connect |