A high speed 12 volt inflator/deflator air pump for rapid dinghy inflation/deflation with various valve nozzles and temperature sensitive air release valve protects from over heating.
A high speed 12-volt inflator and deflator air pump for rapid inflatable dinghy inflation or deflation with various valve nozzles and a temperature sensitive air release valve which protects the pump from overheating.
The Rule ID20 electric inflatable dinghy pump has the capability of inflating a four-man dinghy in approximately 2 minutes. It can also completely remove the air from an inflatable boat making it much easier to fold and store the boat back in its bag.
The ID20 High Speed Inflator is operated by squeezing the large, easy to use hold down trigger button on the side. It comes complete with pre-wired crocodile clips allowing you to connect it directly to a 12-volt battery.
This electric air pump has a series of different air valve adapters that can be interchanged and plugged together in different ways to adapt to a large selection of dinghy valves. The pump doesn't need an airtight seal between the pump and the boat to blow the inflatable boat up due to the amount of air the pump can push into the boat.
A spare set of inflation adapters is available separately in case you miss place the originals.
The air pump can also be used on air beds as an electric fast air bed inflator and can also inflate small PVC dinghies. It is not suitable for blowing up paddleboards (SUP) as they require a higher pressure pump.
The Rule ID20 High Speed Inflator was unavailable for a number of years, however, it was re-introduced in August 2021.
| Voltage | 12v |
| Height | 130mm |
| Width | 95mm |
| Depth | 90mm |
| Wire Length | 3m (10ft) |
| Weight | 750g |
| Airflow | 550 Litres per Minute |
| Pressure | 2.6psi per minute (0.18bar per minute) |
| Released | August 2021 |
