A classically styled 57mm black analogue quartz clock gauge with a shiny stainless steel bezel.
The Clock Gauge With Stainless Steel Bezel is a classically styled black quartz clock with a white 12-hour clock face, a white analogue needle and a shiny stainless steel bezel, it is also waterproof, perfect for classic boats such as Freeman Cruisers.
This classic boat clock comes complete with built-in led backlight illumination in either yellow or red light and is designed for use on 12 volt or 24 volts systems. It also comes complete with a push button to activate the back light when needed and a wiring loom with a quick connect plug to make fitting easier.
This quartz clock has an IP (Ingress Protection) rating of IP67 which means it is completely sealed from dust and is waterproof as it is protected against temporary immersion in water (up to 30 minutes).
The gauge requires a 53mm hole and will fit panels with a thickness from 0.5mm to approximately 20mm, this is achieved thanks to the long threaded body and large plastic nut to lock the clock in position.
The wiring loom is pre-wired to a plug which pushes into the back of the gauge, only three wires are required, Positive, Negative and then either of the back light wires, which can also be put through a switch to provide day time (yellow light) and night time (red light) illumination. A push button switch is included which can be wired to the back light (either colour) and back to the clock gauge to provide intermittent lighting as required.
Voltage | 12v or 24v |
Scale | 12 Hours |
Display | Analogue Needle |
IP Protection | IP67 - Waterproof |
Diameter | 57mm |
Cut Out Diameter | 52mm |
Depth | 62mm |
Depth With Plug | 67mm |
Minimum Clearance Behind | 55mm |
Dashboard Thickness | 0.5mm to 20mm |
Illumination | Yellow or Red |
Connections | 5 Wires on Multi Plug |
Wire Length | 38cm |
Body Material | Plastic |