A classically styled 57mm black digital engine hour gauge with a shiny stainless steel bezel.
The Digital Engine Hours Gauge with Stainless Steel Bezel is a classically styled black gauge with white writing, a black digital numeric display and a shiny stainless steel bezel, perfect for classic boats such as Freeman Cruisers.
The engine hour gauge has a scale from 0 to 99999.9 hours to show the running time of your engine. It is connected to the positive side of the ignition key switch so that it only counts while the engine is running. The engine hours are increased by 0.1 hours every other 6 minutes.
This digital engine hour gauge comes complete with built-in led backlight illumination in either yellow or red light and is designed for use on either 12 volt or 24 volt systems. It also comes complete with a wiring loom with a quick connect plug to make fitting easier.
This digital hour gauge has an IP (Ingress Protection) rating of IP67 which means it is completely sealed from dust and is waterproof as it is protected against temporary immersion in water (up to 30 minutes).
The gauge requires a 53mm hole and will fit panels with a thickness from 0.5mm to approximately 20mm, this is achieved thanks to the long threaded body and large plastic nut to lock the voltmeter in position.
The wiring loom is pre-wired to a plug which pushes into the back of the gauge, only three wires are required, Positive, Negative and then either of the back light wires, which can also be put through a switch to provide day time (yellow light) and night time (red light) illumination.
Voltage | 12v or 24v |
Scale | 0-99999 Hours |
Display | Digital Numbers |
Diameter | 57mm |
Cut Out Diameter | 52mm |
Depth | 62mm |
Depth With Plug | 67mm |
Minimum Clearance Behind | 55mm |
Dashboard Thickness | 0.5mm to 20mm |
Illumination | Yellow or Red |
Connections | 4 Wires on Multi Plug |
Wire Length | 38cm |
Body Material | Plastic |