Water Temperature Gauge With Stainless Steel Bezel
  • Water Temperature Gauge With Stainless Steel Bezel
  • Rear of Gauge
  • Gauge 5 Wire Wiring Loom
  • Gauge With Wiring Loom Plugged In

Water Temperature Gauge with Stainless Steel Bezel

A classically styled 52mm black electrical engine water temperature gauge with a shiny stainless steel bezel.

Add to your basket...

Water Temperature Gauge with Stainless Steel Bezel (EC630)

Price:
£23.50
SRP:
£29.36
You save:
£5.86 (20%)
Quantity:

Water Temperature Gauge with Stainless Steel Bezel Information

The Water Temperature Gauge with Stainless Steel Bezel is a classically styled black gauge with white writing, an analogue white needle and a shiny stainless steel bezel, it is also waterproof, perfect for classic boats such as Freeman Cruisers.

The electrical water temperature gauge has a scale from 40°C to 120°C to show the temperature of the engine cooling water. The gauge requires an appropriate sender to be fitted into the engine to sense the correct water temperature.

Water Temperature Gauge Senders - What Resistance?

This water temperature gauge works with a sensor that reads 300 ohms of resistance at 40°C and 23 ohms at 120°C. There are many different resistances used for temperature senders so it is important to match the gauge with the correct sender. The resistance used for this gauge is based on the European standard, however, there are multiple interpretations of the European standard, therefore we recommend purchasing the specific temperature sender for this gauge.

This classic water temperature gauge comes complete with built-in led backlight illumination in either yellow or red light and is designed for use on 12 volt or 24 volt systems. It also comes complete with a wiring loom with a quick connect plug to make fitting easier.

Waterproof Water Temperature Gauge

This water temperature gauge has an IP (Ingress Protection) rating of IP67 which means it is completely sealed from dust and is waterproof as it is protected against temporary immersion in water (up to 30 minutes).

Water Temperature Gauge with Stainless Steel Bezel Installation

The gauge requires a 53mm hole and will fit panels with a thickness from 0.5mm to approximately 20mm, this is achieved thanks to the long threaded body and large plastic nut to lock the water temperature gauge in position.

The wiring loom is pre-wired to a plug which pushes into the back of the gauge, only four wires are required, Positive, Negative, Sender and then either of the backlight wires, which can also be put through a switch to provide day time (yellow light) and night time (red light) illumination.

Water Temperature Gauge with Stainless Steel Bezel Specification

Voltage 12v
Scale 40°C to 120°C
Display Analogue Needle
Dial Colour Black
Text Colour White
Signal 300 (40°C) to 23 Ohms (120°C)
(Usually used by European Manufacturers)
IP Protection IP67 - Waterproof
Diameter 57mm
Cut Out Diameter 52mm
Depth 62mm
Depth With Plug 67mm
Minimum Clearance Behind 55mm
Dashboard Thickness 0.5mm to 20mm
Illumination Yellow or Red
Connections 4 Wires on Multi Plug
Wire Length 38cm
Body Material Plastic

Included in the Water Temperature Gauge with Stainless Steel Bezel

  • 1 x Fuel Level Gauge
  • 1 x Wiring Loom
  • 1 x Resistor for 24v